Lubricants Start Grip Tape HF (15MA922600-T00T000)

Universal floor grip / grip tape - Contains fluorine for better grip - Temperature range -1°...-20°C - Suitable for all types of snow - Easy to use - One application lasts up to 250 km - Package: 5m, 2-3 pairs of skis to lubricate GRIP TAPE application video here Instructions for use (see also diagram in the package).Clean the area where the skis are held (30-50 cm in the middle of the skis) thoroughly with the grease remover (see instructions on the kit). Make sure the area is completely dry after cleaning.Sand the cleaned area with the sandpaper found on the side of the product - side A (see drawing on the packaging). The entire holding area must be properly sanded, first transversely and then longitudinally.Insert the end of the Grip Tape into the start of the sanded grip area and press down. Apply the lubricating strip of Grip Tape to the entire grip area of the ski.Cut the Grip Tape as follows: press your fingers onto the brake, side C. Cut the Grip Tape as follows. Lift the box upwards. Press side D against the lubricating strip. Twist the cut end in two.To avoid air bubbles between the grease and the ski surface, firmly smooth side E over the entire Grip Tape.Remove the paper with a quick pull. If some air bubbles remain, replace the paper and smooth again with side E and remove the paper.Cool the skis outdoors. Do not touch the lubrication area with your hands and do not squeeze the skis together so that the lubrication areas do not touch.