ULTENIC Pooleco 10 Pool Cleaning Robot (8801480162)

ULTENIC Pooleco 10 Pool Cleaning Robot
The ULTENIC Pooleco 10 is a cordless robot designed for automatic cleaning of pool bottoms. The device is equipped with two powerful motors, a 5200 mAh battery, and an operating system that allows for continuous operation for up to 90 minutes. A single charge, which takes less than 3 hours, allows it to clean an area of up to 80 m². The model is designed for above-ground, in-ground, and indoor pools, and its cordless design eliminates the problem of tangled cords. Operation is controlled with a single button, so getting the device ready for use takes just a moment.


Dual Suction Power and More Effective Debris Removal
The ULTENIC Pooleco 10 robot uses two independent motors to effectively remove debris from the bottom of the pool. Thanks to its dual suction system, the device efficiently collects leaves, insects, sand, dust, and other debris that settles on the surface. This solution helps keep the pool clean with less effort and reduces the need for manual debris removal.


Up to 90 minutes of runtime and fast charging
The high-capacity 5200 mAh battery allows for uninterrupted operation for up to 90 minutes. This is enough time to thoroughly clean an area of up to 80 m² without having to stop and recharge the device. Recharging takes less than 3 hours, and a simple LED indicator shows the charging status. A red light indicates a low battery or that charging is in progress, while a green light means the battery is fully charged.


Cordless design for greater convenience
The absence of cords allows the robot to move freely across the pool floor without the risk of tangling or limiting its operating range. Thanks to its compact size, the device is easy to carry, store, and set up for operation. Simply place the robot in the water and press the start button to begin the automatic cleaning cycle.


Wide compatibility with various surfaces
The ULTENIC Pooleco 10 is designed to work on surfaces made of mosaic, plaster, fiberglass, and vinyl materials. The device works with above-ground, in-ground, and indoor pools, and its design allows for effective operation on surfaces with a slope of up to 10 degrees. The maximum recommended pool depth is 3 meters. It’s important to note that this model is designed exclusively for cleaning the pool bottom and is not intended for cleaning walls, steps, or the waterline.


Simple operation and a practical accessory kit
The robot’s designers focused on intuitive operation and minimizing the number of steps required to start the device. The use of a float with a cord makes it easy to remove the robot from the water, and additional brushes and spare wheels help extend the equipment’s service life. The compact housing, measuring 32.39 × 32.08 × 16.58 cm, makes it easy to store the device even outside of the summer season.



Included in the set
ULTENIC Pooleco 10 robotChargerFloat with cordUser manualTwo brushesTwo spare wheels

 



ManufacturerULTENICModelPooleco 10Device typecordless pool bottom cleaning robotBattery5200 mAhOperating timeup to 90 minutesCharging time≤ 3 hoursMaximum cleaning areaup to 80 m²Number of motors2Maximum surface slope10°Maximum pool depth3 mSupported surfacestile, stucco, fiberglass, vinylDimensions32.39 × 32.08 × 16.58 cmCharge status indicatorLEDIntended usecleaning the pool bottomUnsupported functionscleaning walls, steps, and the waterline